To put the scope in an unlocked position, please note the steps above. Your Ablescope will now straighten back out to it’s original position. Releasing the scope from its locked position: Once the scope is locked into a certain position, it can only be unlocked by pressing the wheel towards the handle with your thumb and forefinger. When the wheel is turned in a counter-clockwise position and gently pulled out, then it is in the locked position. When the wheel on the end of the handle is pressed in and turned in a clockwise direction, the scope is in an unlocked position. Locking and Unlocking: The articulating probe has two positions: Locked and Unlocked
Make sure the connector is screwed in firmly. Please turn off your unit and reconnect the probe. Flashing Screen: If your screen flashes while using your borescope, it is probable that the probe is not securely connected.Check to make sure the protective cover to the probe is still not affixed..Checking the battery to make sure they are still good and connected well inside the handle.Adjusting the light fading switch on your handle which controls the brightness of the lights.No LED Lights: If the lighting on your device is not working, you can try, Turn off your borescope, then try reattaching the monitor to the handle and turn back on. The monitor is not firmly affixed and connected to the handle.The monitor battery has not been charged.The rubber camera cap is still attached to the probe.No Picture on Monitor: There are several scenarios that may cause the monitor not to show video.
Probe Connection: Make sure that your probe is connected firmly into the handle and that the device is screwed on firmly (Note: when screwing on the probe, it should go on smoothly and fully).
If for some reason, you do not get power to your device, you may want to try checking how well Below is a troubleshooting guide list for some of our well-known products.īattery: After removing the battery panel from the handle with a screwdriver, make sure to insert all four batteries facing the correct direction and insert with the bottom tab facing out.
0 kommentar(er)
